Installation:
- Attach the chart to the wall, making sure it is level, using the thumbtacks provided.
If there is a wooden baseboard at the bottom of the wall that prevents you from using thumbtacks, attach the chart just above the baseboard, making sure that the bottom edge (below the baseboard) remains straight and does not move. Avoid using rubber bands or temporary adhesives.
Important : The chart must not touch the floor and must not have any creases at the bottom.
- Locate the vertical center of the chart.
- Install the hook in the ceiling, centered relative to the chart and located approximately 1 meter (39.4 inches) from the wall, using the appropriate anchor for your ceiling type; two types of anchors are provided: one for drywall and one for suspended ceilings. Make sure the string is properly positioned in the center of the grid.
- Adjust the length of the string so that the weight is no more than 1 cm from the floor, without touching it. The measurement is taken from the tip of the weight.
*Note : The weight and cord must hang almost to the floor to allow for the analysis of imbalances in the foot and ankle.
- Hang the weight from the cord by hooking it onto the hook.
- Check the alignment: the cord must be centered with the chart.
